To synchronize external events to image data, ScanImage 2015 allows to record precise timestamps for up to four auxiliary digital trigger lines (currently only supported in resonant scanning mode). To achieve the highest temporal resolution and accuracy, the timestamps are generated on the FPGA which is also responsible for image formation. An additional NI SCB-19 breakout box is required to feed the trigger input signals through the NI FlexRIO digitizer adapter module (NI5732/NI5734) to the FPGA.
The timestamps for detected triggers are written to the Tiff header of the frame that was currently being acquired when the trigger occurred. If a trigger occurs in a pause between two acquisitions in Loop mode, the trigger timestamp is written to the first frame of the acquisition following the pause.
The following example shows the Tiff image description for two detected triggers on PFI1.
The temporal resolution of the timestamp is equal to the NI FlexRIO digitizer sample period (NI5732: 12.5ns, NI5734: 8.33ns). Because of the high sample rate for the trigger lines, noise on the input signal can result in one edge to be registered as multiple triggers. To get around this problem, ScanImage requires an input line to be stable for a certain time before a trigger is registered. This method is called 'debouncing'. Since debouncing is a type of low-pass filter, the delay between the occurence of the trigger and the registration of the trigger would influence the accuracy of the timestamp. However, ScanImage corrects for this delay so that the timestamp accuracy does not suffer from trigger line debouncing.